Sorting and view mode

Copper Plate L.W Buck Esq. - Circa 1808-1833

Copper Plate L.W Buck Esq., © Wedgwood Museum
    Copper Plate L.W Buck Esq.
    © Wedgwood Museum

This Copper Plate was produced as an armorial ware commission by L.W Buck Esq.

The Crest Order Book 1817-1833 shows that three orders for creamware were placed that were to be decorated with a "gold wreath purple lines with crest in centre". In total these orders consisted of 50 pieces of ware. Two subsequent orders were made for creamware with rose colour designs, consisting of 17 pieces.

  • Type of object: Manufacturing paraphernalia and miscellany/engraving
  • Mark: CP118, CP118a, CP118b, CP118c: L. W. Buck Esq (engraved on reverse).
  • Year produced: Circa 1808-1833
  • Body: Copper
  • Material: metal
  • Decoration: engraved
  • Accession number: CP118/ CP118a/ CP118b/CP118c
  • Dimensions: CP118: 85 mm x 61 mm; CP118a: 85 mm x 74 mm; CP118b: 50 mm x 48 mm; CP119c: 39 mm x 35 mm

Other images


  • Copper Plate Engraving

    Copper Plate Engraving

    Copper plates were used in the ceramics trade from the mid 18th century. Josiah Wedgwood (1730-1795) used Liverpool partners Guy Green and John Sadler to supply him with a selection of transfer-printed designs for his cream-coloured earthenware (Queen's ware).

    The process of using copper plates involves firstly creating a design by way of etching it on to a flat copper plate. A heated mixture of oil and colourring oxide is applied to the plate and wiped off, leaving the colour lying within only the lines of the of the engraved design. A sheet of wet tissue paper is then laid on the plate and a thick pad of flannel placed on top. The sandwich is then repeatidly pressed and after a whiile the tissue peeled off of the copper. The tissue is then applied to the surface of the ware and again rubbed in order to transfer the print from the tissue onto the ware itself. The paper is then gently washed off leavbing just the design printed on the ware. The ware is then fired in order to permenantly adhere the design to the ware.

    Copper plate engravings were also used in a process known as Bat printing. A glue bat is an animal glue, produced from boiling up bones and skins, to which was added ale and ising glass, was then poured into shallow pans and allowed to set to a thin jelly sheet, about one eighth of an inch thick. This sheet, or bat, had a smooth shiny surface ideally suited to hold the tiny amount of oil used in the transfer process. The copper plate was lightly oiled, the surface being wiped to leave oil only in the indentations of the design. The bat  was pressed firmly against the plate and lifted to leave the design in oil on the glue surface. The bat was then applied to the glazed ceramic, pressed down and carefully lifted away, the design in oil transferred now to the surface of the glaze. This oil outline is then dusted with powdered ceramic colour.